Figure 9. Installing a solid-state drive in the EDR1 PCIe storage enclosure
7. On the console, press Enter to indicate that you have installed the drive.
Proceed to the procedure for verifying the drive installation. For instructions, go to "Verifying that the
new disk drive or solid-state drive is installed and operational."
Verifying that the new disk drive or solid-state drive is installed and operational
Press Enter on the Complete Device Concurrent Add display to indicate that the disk drive or solid-state
drive is installed. The identify LED turns off.
Complete the following steps to verify that the new disk drive or solid-state drive is operational:
1. Log in as root user.
2. Type iprconfig on the command line of the Linux session and press Enter. The IBM Power RAID
Configuration Utility display is shown.
3. Select Display hardware status. The Display Hardware Status display is shown, similar to the
following figure.
18
Disk drives or solid-state drives