Installing The Service Access Cover On A Rack-Mounted 8202-E4B, 8202-E4C, 8202-E4D, 8205-E6B, 8205-E6C, Or 8205-E6D System; Installing The Service Access Cover On A Stand-Alone 8202-E4B, 8202-E4C, 8202-E4D, Or 8205-E6B System - IBM 8202-E4B Manual

Installing the service access cover on a rack-mounted 8202-E4B,
8202-E4C, 8202-E4D, 8205-E6B, 8205-E6C, or 8205-E6D system
Use this procedure to install the service access cover.
1. Place the service access cover on top of the system, about 25 mm (1 in.) from the upper chassis ledge.
2. Hold the service access cover against the system unit and slide it toward the front of the system. The
tabs of the service access cover slide beneath the upper chassis ledge.
3. Align the two thumbscrews (A) located on the rear of the service access cover with the two holes on
the rear of the system chassis.
4. Tighten the thumbscrews to secure the service access cover.
Figure 118. Installing the service access cover
Installing the service access cover on a stand-alone 8202-E4B,
8202-E4C, 8202-E4D, or 8205-E6B system
Use this procedure to install the service access cover.
1. Place the inside service access cover (A) on top of the system, about 25 mm (1 in.) from the upper
chassis ledge.
2. Hold the service access cover against the system unit and slide it toward the front of the system. The
tabs of the service access cover slide beneath the upper chassis ledge.
3. Align the two thumbscrews (B) located on the rear of the service access cover with the two holes on
the rear of the system chassis.
4. Tighten the thumbscrews to secure the service access cover.
158
Disk drives or solid-state drives