Installing A Disk Drive Or Solid-State Drive In The 8202-E4B, 8202-E4C, 8202-E4D, 8205-E6B, 8205-E6C, Or 8205-E6D System Or Expansion Unit - IBM 8202-E4B Manual

The Device Concurrent Maintenance is displayed, as shown in the following figure.
Device Concurrent Maintenance
Type the choices, then press Enter.
Specify either physical location or resource name.
Physical location:
U787A.001.1234567-P3-D4
or
Device resource name:
Specify action as 1=Remove device 2=Install device
Action to be performed . . . . . . . .: 2
Enter a time value between 00 and 19.
Time delay needed in minutes . . . . .: 01
F3=Exit F5=Refresh
Figure 12. Example Device Concurrent Maintenance display
9. In the Specify either physical location or resource name field, type the physical location that you
had previously recorded in this procedure.
10. Select 2 (Install device) for the Action to be performed.
11. Set the time delay, for example, for one minute: 01.
Note: You can set an appropriate time delay of 01 - 19 minutes to allow adequate time to access the
disk drive or solid-state drive.
12. Do not press Enter yet, first complete installing the disk drive or solid-state drive.
Choose from the following options:
v If you are installing a drive in a system or an expansion unit, proceed to "Installing a disk drive or
solid-state drive in the 8202-E4B, 8202-E4C, 8202-E4D, 8205-E6B, 8205-E6C, or 8205-E6D system or
expansion unit."
v If you are installing a drive in the 5887 disk drive enclosure, proceed to "Installing a disk drive or
solid-state drive in the 5887 disk drive enclosure" on page 24.
v If you are installing a drive in the EDR1 PCIe storage enclosure, proceed to "Installing a solid-state
drive in the EDR1 PCIe storage enclosure" on page 24.
Installing a disk drive or solid-state drive in the 8202-E4B, 8202-E4C, 8202-E4D,
8205-E6B, 8205-E6C, or 8205-E6D system or expansion unit
Complete the following steps to install a disk drive or solid-state drive in a system or in an expansion
unit:
22
Disk drives or solid-state drives
F12=Cancel