Replacing A Solid-State Drive In The Edr1 Pcie Storage Enclosure; Completing The Procedure - IBM 8202-E4B Manual

Figure 55. Replacing a solid-state drive in the EDR1 PCIe storage enclosure.
Proceed to the procedure for completing the drive replacement. For instructions, see "Completing the
procedure."

Completing the procedure

Complete the following steps after you install or replace the disk drive or solid-state drive in a system,
enclosure, or expansion unit:
1. Replace the front cover:
v For instructions for a rack-mounted system, see "Installing the front cover on a rack-mounted
8202-E4B, 8202-E4C, 8202-E4D, 8205-E6B, 8205-E6C, or 8205-E6D system" on page 153.
v For instructions for a stand-alone system, see "Installing the front cover and front door on a
stand-alone 8202-E4B, 8202-E4C, 8202-E4D, or 8205-E6B system" on page 154.
2. Start the system or logical partition. For instructions, see "Starting the system or logical partition" on
page 145.
3. Verify the installed part:
v If you replaced the part because of a failure, verify the installed part. For instructions, see
"Verifying a repair" on page 177.
v If you installed the part for any other reason, verify the installed part. For instructions, see
"Verifying the installed part" on page 165.
4. To configure the newly installed disk drive or solid-state drive, see the following procedures for the
applicable operating system that controls the disk drive or solid-state drive:
v "Preparing a disk drive or solid-state drive for use in an AIX system or logical partition" on page
107.
v "Configuring a disk drive or solid-state drive in an IBM i system or logical partition" on page 115.
Note: There is no equivalent procedure for a system or logical partition that is running the Linux
operating system.
84
Disk drives or solid-state drives