Go On Line - Parker H Series Installation & Service Instructions Manual

5-4 Add the H Series Fieldbus DeviceNet Adapter to the DeviceNet Scanner's Scanlist
The following screens show the remaining confi guration windows.
I/O Data window
Connection sizes
appear only when the
Subnet network fi le
has been associated
in the Device
Bridging window.
These values
correspond to the
4 parameters (Poll/
COS Connection
Consume Size,
Poll Connection
Produce Size, COS
Connection Produce
Size, Strobe
Connection Produce
Size) found in the
device's Parameters
window.
EDS File window
Click here to view the
EDS file. An example
of the EDS file is
shown below.
The window below shows an example EDS fi le.
This completes the confi guration options. Your adapter must go on
line for the confi guration to take effect.
Publication PSS-UM001A-EN-P – December 2016

Go On Line

Follow these steps for the adapter to go on line:
1. Use the Network pulldown.
1. Click on Network.
2. Click on Online.
The software prompts you to save your confi guration changes.
Click Yes.
2. Choose your adapter's network as shown below.
Select the DeviceNet
network.
This selection accesses
the PointBus to configure
the adapter on the
DeviceNet network.
Click OK to apply the
data to your adapter.
To learn how to add the H Series Fieldbus DeviceNet adapter to
the scanner's scanlist, refer to the Quick Start section, Appendix B.
Chapter Summary and What's Next
In this chapter, you learned how to confi gure the adapter.