Connect A Power Supply To Round Media - Parker H Series Installation & Service Instructions Manual

3-16 Make Cable Connections
5-pin Micro Female
V+
2
mechanical key
1
not used
Connect a Power Supply to
Round Media
Publication DNET-UM072C-EN-P - July 2004
Pinout diagrams for mini and micro connections to the power cable are shown
below.
user defined
V-
3
5
user defined
4
user defined
user defined
To supply power you will need to install and ground the power supplies as well
as connect all PowerTap taps. If you haven't determined power supply
placement, see Chapter 4.
To install a power supply:
ATTENTION
1. Mount the power supply securely allowing for proper ventilation,
connection to the ac power source, and protection from environmental
conditions according to the specifications for the supply.
2. Connect the power supply using:
• a cable that has one pair of 12 AWG (3.3mm
equivalent or two pairs of 15 AWG (1.7mm
• a maximum cable length of 3m (10 ft) to the PowerTap tap
• the manufacturer's recommendations for connecting the cable to the
supply
5-pin Mini Female
mechanical key
not used
1
5
4 2
V+
3
V-
Make sure the ac power source remains off during
installation.
4-pin Mini Female
mechanical key
user defined
1
4
3 2
V+
30498-M
2
) conductors or the
2
) conductors
V-
user defined