Install Kwiklink Cable And Kwiklink Heavy-Duty Connectors - Parker H Series Installation & Service Instructions Manual

3-10 Make Cable Connections
Install KwikLink Cable and
KwikLink Heavy-Duty
Connectors
Class 1 (CL1) KwikLink Cable
Spool Size Catalog Number
75 m (246 ft) 1485C-P1E75
200 m (656 ft) 1485C-P1E200
420 m (1378 ft) 1485C-P1E420
Class 2 (CL2) KwikLink Cable
Spool Size Catalog Number
75 m (246 ft) 1485C-P1G75
200 m (656 ft) 1485C-P1G200
420 m (1378 ft) 1485C-P1G420
Publication DNET-UM072C-EN-P - July 2004
4. Make the connection to the trunk line last.
Follow the wiring diagrams for each connection, and make
IMPORTANT
sure you do not exceed the maximum allowable length
from the device connection to the trunk connection.
Install KwikLink cable with the wider, flat edge of the cable on the bottom.
Follow these steps to properly install KwikLink cable into a connector:
1485-P1Kxxx cable cannot be used with KwikLink
IMPORTANT
heavy-duty connectors.
1. Lay the cable in the hinged base, paying attention to the keyed profile.
The unkeyed edge is closer to the hinge; the keyed edge is toward the
latch.
Prior to closing the connector, make sure the IDC blades
IMPORTANT
do not protrude from the housing. If the blades are
exposed, gently push them back into the base. In the event
that the blades do not retract easily (or retract only
partially), verify that the IDC screws are not partially
driven.
keyed edge
flat edge
41607
keyed edge is toward
the latch
latch
30474-M