Confi Guration Overview; Add The Adapter To Your Network - Parker H Series Installation & Service Instructions Manual

Add the H Series Fieldbus DeviceNet
Adapter to the DeviceNet Scanner's
Scanlist
This chapter describes how to custom confi gure your adapter for
use with DeviceNet devices.
See the Following Sections:
Confi guration Overview

Add the Adapter to Your Network

Set the Adapter's Parameters
Go On Line
Chapter Summary
Your adapter works on two networks simultaneously and must be
confi gured for each separately, which means that you will have
two separate RSNetWorx for DeviceNet software fi les.
This chapter explains confi guration of the adapter for use on the
primary DeviceNet network. For information on how to confi gure
the adapter for use on the Subnet, see Chapter 4, Confi gure the
DeviceNet Scanner Subnet.
Confi guration Overview
You must use the RSNetWorx for DeviceNet software to confi gure
your adapter. You can confi gure the adapter while it is:
• On line
• Off line
This chapter shows confi guration in the offl ine mode. Confi guration
screens appear the same in both modes. Note that some screen
options are unavailable in offl ine mode. The only difference is that if
you make changes off line, you must take the adapter on line before
the confi guration changes take effect.
You must follow these steps during confi guration:
1. Add the adapter to your network
2. Set the adapter's parameters
3. Add the DeviceNet adapter's scanlist (see the Quick Start,
Appendix B)
4. Go on line
Page:
5-1
5-1
5-2
5-4
5-4
Add the Adapter to Your Network
Follow these steps:
1. Start the RSNetWorx for DeviceNet software.
2. Add the adapter as shown below.
1. Expand the list of
Communication
Adapters.
Publication PSS-UM001A-EN-P – December 2016
Chapter
2. To add the adapter, you can double
click on the adapter, or click and drag
the adapter name onto the network.
5