1-2
Install the H Series Fieldbus DeviceNet Adapters
Wire the DeviceNet Adapters
Following are wiring instructions for the DeviceNet Adapters.
PSSCDM12A
Male In Connector
PSSCDM18PA
Male In Connector
DeviceNet Auxiliary Power
Male In Connector
ATTENTION
!
Make sure all connectors and caps are securely tightened to
properly seal the connections against leaks and maintain IP67
requirements.
Publication PSS-UM001A-EN-P – December 2016
(view into connector)
Pin 1 - Drain
Pin 2 - +V
Pin 3 - -V
Pin 4 - CAN_High
Pin 5 - CAN_Low
(view into connector)
Pin 1 - Drain
Pin 2 - +V
Pin 3 - -V
Pin 4 - CAN_High
Pin 5 - CAN_Low
(view into connector)
Pin 1 - User Power +
Pin 2 - Adapter Power +
Pin 3 - Adapter Power -
Pin 4 - User Power -
Chapter Summary and What's Next
In this chapter, you learned how to install and wire your
DeviceNet adapter. Move to Chapter 2 to learn about
the H Series Fieldbus DeviceNet adapters.
Female Out Connector
Female Out Connector