List Of Selectable States In Hmi Advanced; Machine Operating Area; Parameters Operating Area - Siemens SINUMERIK 840D sl Commissioning Manual

Expanding the Operator Interface (BE1)
5 Configuring OP Hotkeys and PLC Keys

5.5 List of selectable states in HMI Advanced

Setting tasks in HMI Advanced
In general, the following conditions apply to all tasks:
No configuration:
Configuration with 0:
5.5.1

Machine operating area

In the Machine operating area, the status is always dependent on the status of the
machine (AUTO, MDA, JOG, REF). The following can be accessed via the PLC
key:
1.) The main screen for the relevant mode
State
0
0
0
0
0
0
0
2.) The main actual value screens for each mode (softkey vertical 6)
State
10
20
30
3.) Possibly still in jog / MDA
State
60
70
80
Switching between the WCS and MCS is possible via the PLC.
5.5.2

Parameters operating area

It is not possible to move from the current screen in this area.
BE1/5-134
SINUMERIK 840D sl/840D/840Di/810D HMI Installation and Start-Up Guide (IAM) – 08/2005 Edition
Maintains current state
Reverts to the initial state of an operating area.
Mode Machine funct.
group
JOG REF
JOG none
JOG REPOS
MDA none
MDA TEACH
MDA REF
AUTO none
Mode Machine funct.
group
JOG none
MDA none
AUTO none
Mode Machine funct.
group
JOG none
JOG none
MDA none
Displays
JOG/REF main screen
JOG main screen
REPOS main screen
MDA main screen
MDA/Teach main screen
MDA/REF main screen
Auto main screen
Displays
Zoom actual values JOG
Zoom actual values MDA
Zoom actual values Auto
Displays
Handwheel selection JOG
Increment selection JOG
Handwheel selection MDA
© Siemens AG, 2005. All rights reserved
08/2005