Siemens SINUMERIK 840D sl Commissioning Manual page 18

Commissioning cnc part 2 (hmi)

Hide thumbs Also See for SINUMERIK 840D sl:

Table of Contents

Expanding the Operator Interface (BE1)

1 Introduction

Commands, which have not yet been implemented, are specified at a number of

places in this document. Please refer to the Index for the corresponding

command with page reference.

SINUMERIK 840D sl/840D/840Di/810D HMI Installation and Start-Up Guide (IAM) – 08/2005 Edition

Call a text from a separate text file. Texts used in screen forms

can be specified explicitly in configuration files or, particularly

in cases where screen forms are to be displayed in different

languages, stored separately in text files.

Language-dependent texts can be used for:

Softkey labels

Any other texts

The screen forms refer to texts in different text files via text

identification numbers (number after the $ character). Text files

are usually language-dependent. Entries in control files

determine which text files must be activated

The structure of the configuring environment in Chapter 7

describes how selected text files can be activated for the target

systems HMI Embedded/HT6 and HMI Advanced.

The syntax for creating screen form texts in separate files is

also to be found in Chapter 7.

is text defined by the user and can be entered directly as

such in the configuration file.

Notations $8xxxx and "text" can be used as alternatives.

Chapters

Table of Contents