Siemens SINUMERIK 840D sl Commissioning Manual page 264

Commissioning cnc part 2 (hmi)

Hide thumbs Also See for SINUMERIK 840D sl:

Table of Contents

Starting Up HMI Embedded (IM2)

2 Power On and Ramp-Up

You need to insert the CompactFlash Card containing the HMI Embedded software

into the slot marked "CF" (interface X109) before switching on the NCU.

Once the power supply is switched on, the NCU ramps up automatically and

detects the CompactFlash card.

An 8-digit HMI Embedded version number is displayed during ramp-up. The

seconds-counter display can be used to monitor when the connection to the

NCK/PLC has been established.

Further information about the ramp-up is contained in the submanual of the CNC

Installation and Startup Manual Part 5 (Base Software):

References: IAM2/IM5: Installation and Startup TCU, Section:

SINUMERIK 840D sl/840D/840Di/810D HMI Installation and Start-Up Guide (IAM) – 08/2005 Edition

Operation during ramp-up.

Chapters

Table of Contents