Nortel 4500 Series Overview-System Configuration page 265

LLDP configuration example
To configure the example shown above, you must perform the following
tasks:
Step
1
2
3
4
5
6
7
Copyright © 2007, Nortel Networks
.
Action
Modify the default LLDP Tx interval from (the default 30 second
value) to 60 seconds.
Note that if any modification is detected in the LLDP local-sys-data
before the Tx interval expires, an LLDPDU is immediately sent on all
active links in order to update the peers neighbor tables.
Enable the Port Description TLV for transmission. (contains the
description of the LLPD sending port)
Enable the System Name TLV for transmission. (contains the name
of the LLDP device)
Enable the System Description TLV for transmission. (contains the
description of the LLDP device)
Enable the System Capabilities TLV for transmission. (contains the
capabilities of the LLDP device)
Enable the Management Address TLV for transmission. (contains
the management address of the LLDP device)
Enable the Port VLAN ID TLV for transmission. (contains the PVID
of the LLDP sending port)
Nortel Ethernet Routing Switch 4500 Series
Overview — System Configuration
NN47205-500 02.01 Standard
5.0 23 February 2007
Configuring LLDP using the CLI 265
Nortel Networks Confidential