Nortel 4500 Series Overview-System Configuration page 188

188 Switch administration tasks
"no SNTP server parameters" (page 188)
this command.
no SNTP server parameters
Parameters
primary
secondary
SNTP sync-now command
The SNTP sync-now command forces a manual synchronization with the
NTP server.
The syntax for the SNTP sync-now command is
sntp sync-now
Run the SNTP sync-now command in Global Configuration command
mode.
SNTP sync-interval command
The SNTP sync-interval command specifies recurring synchronization
with the secondary NTP server in hours relative to initial synchronization.
The syntax for the SNTP sync-interval command is
sntp sync-interval <0-168>
Run the SNTP sync-interval command in Global Configuration
command mode.
"SNTP sync-interval parameters" (page 188)
command.
SNTP sync-interval parameters
Parameters and
Variables
<0-168>
Copyright © 2007, Nortel Networks
.
Note: SNTP must be enabled before this command can take effect.
Note: 0 is boot-time only, and 168 is once a week.
Nortel Ethernet Routing Switch 4500 Series
Overview — System Configuration
NN47205-500 02.01 Standard
5.0 23 February 2007
describes the parameters for
Description
Clear the primary SNTP server address.
Clear the secondary SNTP server address.
Description
Enter the number of hours for periodic synchronization
with the NTP server.
describes the for this
Nortel Networks Confidential