Cli Command Modes - Nortel 4500 Series Overview-System Configuration

Ethernet routing switch
Hide thumbs Also See for 4500 Series:
Table of Contents

Advertisement

CLI command modes

The CLI has four command modes based on the level of permissions
assigned to you. The password that you use to log on determines the
level of permissions. Each command mode provides access to a specific
group of commands.
The four command modes, from most to least restricted, are
The Command modes table lists the four command modes, the prompt for
each, the CLI commands to use to proceed to the next mode, and the CLI
commands to enter and exit the modes. Each switch displays a prompt
specific to the switch type. The prompts displayed in the table are for a
Nortel Ethernet Routing Switch 4500 Series 4548-GT-PWR switch.
Command modes
Current command
mode
User EXEC
Copyright © 2007, Nortel Networks
.
User EXEC mode
The User EXEC mode (also referred to as exec mode) is the default CLI
command mode. User EXEC is the initial mode of access when you
first turn on a switch. User Exec mode provides a limited subset of CLI
commands, is the most restrictive CLI mode, and has few privileges.
Privileged EXEC mode
Use Privileged EXEC mode (also referred to as privExe mode) to
perform basic switch-level management tasks, such as downloading
software images, setting passwords, and booting the switch.
Global Configuration mode
Use Global Configuration mode (also referred to as config mode) to set
and display general configurations for the switch, such as IP address,
SNMP parameters, Telnet access, and VLANs.
Interface Configuration mode
Use Interface Configuration mode (also referred to as if-config mode) to
configure parameters, such as speed, duplex mode, and rate-limiting,
for each port or VLAN.
CLI prompt
4548GT-PWR>
Nortel Ethernet Routing Switch 4500 Series
Overview — System Configuration
NN47205-500 02.01 Standard
5.0 23 February 2007
Command line interface 21
To move up to
To leave
the next mode
current mode
Use the enable
Use one of
command to
the following
move to the
commands to
Privileged EXEC
close the CLI
mode.
session:
Nortel Networks Confidential
exit
logout

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

4526fx4548gt-pwr4550t4550t-pwr4548gt

Table of Contents