186 Switch administration tasks
•
•
Show SNTP command
The show SNTP command displays the SNTP information, as well as the
configured NTP servers.
The syntax for the show SNTP command is
show sntp
Run the show SNTP command in Privileged EXEC command mode.
show sys-info command
The show sys-info command displays the current system characteristics.
The syntax for the show sys-info command is
show sys-info
Run the show sys-info command in Privileged EXEC command mode.
SNTP enable command
The SNTP enable command enables SNTP.
The syntax for the SNTP enable command is
sntp enable
Run the SNTP enable command in Global Configuration command mode.
No SNTP enable command
The no SNTP enable command disables SNTP.
The syntax for the no SNTP enable command is
no sntp enable
Run the no SNTP enable command in Global Configuration command
mode.
SNTP server primary address command
The SNTP server primary address command specifies the IP
addresses of the primary NTP server.
Copyright © 2007, Nortel Networks
.
"SNTP sync-now command" (page 188)
"SNTP sync-interval command" (page 188)
Note: You must have SNTP enabled and configured to display GMT
time.
Note: The default setting for SNTP is Disabled.
Nortel Ethernet Routing Switch 4500 Series
Overview — System Configuration
NN47205-500 02.01 Standard
5.0 23 February 2007
Nortel Networks Confidential