Show Lldp Port Command - Nortel 4500 Series Overview-System Configuration

264 Link Layer Discovery Protocol (802.1ab)

show lldp port command

The show lldp port command displays the LLDP port parameters. The
syntax for the show lldp port command is
show lldp port <portlist> [rx-stats] [tx-stats] [pdu-tlv-si
ze] [tx-tlv {dot1 | dot3 }]
[neighbor {dot1 [vlan-names | protocol-id] } | [dot3]
Run the show lldp port command in Privileged EXEC command mode.
show lldp port command parameters
Parameters and variables
rx-stats
tx-stats
pdu-tlv-size
tx-tlv {dot1 | dot3 }
neighbor { dot1 [vlan-names
| protocol-id] } |
[dot3] | [detail]
[neighbor-mgmt-addr]
LLDP configuration example
By default, LLDP is enabled for Tx and Rx on all switch ports. The default
value for the LLDP Tx interval is 30 seconds (LLDPDUs are sent at 30
seconds). With the default settings, only the mandatory TLVs are sent, but
the switch can receive any LLDP Core, DOT1, or DOT3 TLV from its peers.
"LLDP configuration example" (page 265)
Copyright © 2007, Nortel Networks
.
Description
The LLDP receive statistics for the local port.
The LLDP transmit statistics for the local port.
The different TLV sizes and the number of TLVs
in an LLDPDU.
Display which TLVs are transmitted from the
local port in LLDPDUs:
•
•
To display the transmission status of the
optional management TLVs, include only the
tx-tlv parameter in the command.
The port neighbor TLVs:
•
•
•
The port neighbor LLDP management address.
Nortel Ethernet Routing Switch 4500 Series
Overview — System Configuration
NN47205-500 02.01 Standard
5.0 23 February 2007
dot1: displays status for 802.1 TLVs
dot3: displays status for 802.3 TLVs
dot1: displays 802.1 TLVs:
— vlan-names: VLAN Name TLV
— protocol-id: Protocol Identity TLV
dot3: displays 802.3 TLVs
detail: displays all TLVs.
Nortel Networks Confidential