Nortel 4500 Series Overview-System Configuration page 102

102 Basic configuration tasks
The syntax for the configure network command is
configure network load-on-boot {disable | use-bootp |
use-config} address
"configure network parameters" (page 102)
this command.
configure network parameters
Parameter
load-on-boot {disable |
use-bootp | use-config}
address
<XXX.XXX.XXX.XXX>
filename <name>
You must run this command in the Privileged EXEC mode.
You can view the current switch settings for this process using the show
config-network command. This command takes no parameters.
Using the JDM
Enable this feature through the Java Device Manager (JDM) by using the
File System screen. To automatically download a configuration file, perform
the following procedure.
Step
1
Copyright © 2007, Nortel Networks
.
<XXX.XXX.XXX.XXX>
Action
Open the File System screen by selecting Edit > File System from
the JDM menu.
Nortel Ethernet Routing Switch 4500 Series
Overview — System Configuration
NN47205-500 02.01 Standard
5.0 23 February 2007
filename
outlines the parameters for
Description
The settings to automatically load a
configuration file when the system boots:
• disable: disable the automatic loading of
config file
• use-bootp: load the ASCII configuration
file at boot and use BootP to obtain values
for the TFTP address and file name
• use-config: load the ASCII configuration
file at boot and use the locally configured
values for the TFTP address and file name
Note: If you omit this parameter, the system
immediately downloads and runs the ASCII
configuration file.
The IP address of the TFTP server.
The name of the configuration file to use in
this process
<name>
Nortel Networks Confidential