184 Switch administration tasks
Parameters and
values
no rate-limit command
The no rate-limit command disables rate-limiting on the port.
The syntax for the no rate-limit command is:
no rate-limit [port <portlist>]
Run the no rate-limit command in Interface Configuration command
mode.
"No rate-limit parameters" (page 184)
command.
No rate-limit parameters
Parameters
port <portlist>
default rate-limit command
The default rate-limit command restores the rate-limiting value for
the specified port to the default setting.
The syntax for the default rate-limit command is
default rate-limit [port <portlist>]
Run the default rate-limit command in Interface Configuration
command mode.
Copyright © 2007, Nortel Networks
.
Description
•
broadcast: Apply rate-limiting to broadcast
packets.
•
both: Apply rate-limiting to both multicast and
broadcast packets.
Description
Specify the port numbers to disable for rate-limiting.
Enter the port numbers to disable.
Note: If you omit this parameter, the system uses the
port number you specified in the interface command.
Nortel Ethernet Routing Switch 4500 Series
Overview — System Configuration
NN47205-500 02.01 Standard
5.0 23 February 2007
describes the parameters for this
Nortel Networks Confidential