Commissioning Measurements - Siemens SINUMERIK Series Function Manual

03/2012
PROG_END:
G4 F1
M17

2.3.5 Commissioning measurements

Function description
The prolog and epilog program must be edited in order to perform measurements.
If measurements are performed on a machine for the first time, or if the prolog and
epilog program has been deleted, then a preconfigured prolog and epilog program
takes effect, which prevents the further execution of the NC programs as the NC
program code runs in an endless loop. This part of the preconfigured prolog and
epilog program must be deleted. A program code adapted to the requirements of
the machine must be used for the prolog or epilog.
Fig. 2-38: Prolog and epilog program
© Siemens AG 2012 All Rights Reserved
ePS Network Services, Function Manual (FH) - 03/2012
2 Machine Information
2.3 Test series on the machine
; is required for synchronization
2-67