Siemens SINUMERIK Series Function Manual page 156

3 Setting up functions
3.4 Fault services
Function
-
On the client
side
- On the ser-
ver side
Reset
- When clos-
ing
the mainte-
nance job
- When exe-
cuting
the control
monitor
Start date
3-156
Description
machine expires, then this signals the server in
order to execute the programmed actions in the
control monitor. All actions can be selected.
Triggering on the server side runs independently
of the machine. The machine can even be swit-
ched-off. Only those actions can be selected,
which do not require any online data from the
machine.
Without a specifically selected reset function, the
next maintenance job is always created again in
the programmed time grid - independent of clos-
ing the maintenance job.
The restart of the trigger time can be set so that
this only starts again after the maintenance job
has been closed.
The next maintenance job is determined by the
time interval set from the time of closing. This
means that it does not make any difference if a
maintenance measure was performed too early
or too late.
A maintenance job can be initiated by the time-
based trigger described here - and also by other
event triggers that have been ORed.
The restart of the trigger time is realized by each
trigger of the control monitor used which then
generates the maintenance job.
A date can be entered individually to start the
intervals.
Once the interval has expired, the trigger is
initiated.
The date is limited to 24 months in the future
and 24 months in the past.
If there are no entries and no common start date
is found, then a message is output to enter a
date.
If participation in common start date is selected,
you cannot make any entries here.
When you select the calendar field, the calendar
opens to display the current month.
You can navigate through the months in the
calendar via the arrows. Select a number to use
the date as the start date.
The date is limited to 24 months in the future
and 24 months in the past.
ePS Network Services, Function Manual (FH) - 03/2012
Type
DISPLAY
SELECTION
DISPLAY
DISPLAY
INPUT
(Date format
with leading
zeros)
SELECTION
© Siemens AG 2012 All Rights Reserved
03/2012