Siemens SINUMERIK Series Function Manual page 107

03/2012
To add, remove, or change the sequence of measurement series, these are se-
lected in the overview displayed and moved by dragging and dropping or using the
arrow buttons on the form.
A test series can only contain measurement series in one channel. It is not possible
to change the channel of a test series.
Availability and privileges
Test series can only be configured on the PC. The authorization required for con-
figuring the test series is described in detail in the Appendix.
Saving axis test data
Depending on the setting in the organizational data, changes can be made to the
data relevant for the axis test (prolog and epilog, as well as parameters) while re-
taining the identifier for an already successfully performed manual axis test. In this
case, activate the checkbox and click "OK".
If the checkbox is not set and you click "OK", the identifier for the performed axis
test is reset. It must be performed manually again.
Click "Cancel" to reject the changes made. Any existing identifier for a successful
axis test is retained.
Fig. 3-17: Saving axis test data
© Siemens AG 2012 All Rights Reserved
ePS Network Services, Function Manual (FH) - 03/2012
3.2 Configuring measurements and measurement series
3 Setting up functions
3-107