Omron Sysmac FH Series Hardware Setup Manual page 77

Connector name
(A) SD memory card
installation con-
nector
(B) USB2.0 connector Connects to USB 2.0. Do not plug or unplug it during measurement. Otherwise
(C) USB3.0 connector Connects to USB 3.0. Do not plug or unplug it during measurement. Otherwise
(D) Ethernet connec-
tor
(E) RS-232C connec-
tor
(F) Monitor connector
(G) I/O (Parallel) con-
nector (control
lines, data lines)
(H) Camera connec-
tor
(I) Power supply ter-
minal connector
(A)
(C)
(E)
(G)
(H)
LED name
(A) PWR LED
(B) ERROR LED
(C) RUN LED
(D) ACCESS LED
(E) SD PWR LED
(F) SD BUSY LED
FH Series Vision System Hardware Setup Manual (Z366-E1)
Install the SD memory card. Do not plug or unplug the SD memory card during
measurement operation. Otherwise measurement time may be affected or data
may be destroyed.
measurement time may be affected or data may be destroyed.
measurement time may be affected or data may be destroyed.USB 3.0 has a
high ability to supply the bus power. Use the Sensor Controller by combining
USB 3.0, faster transport can be realized.
Connect an Ethernet device.Ethernet port, EtherNet/IP port, and PROFINET port
are sharing use.
Connect an external device such as a PLC.
Connect a monitor.
Connect the controller to external devices such as a sync sensor and PLC.
Connect cameras.
Connect a DC power supply. Wire the FH Sensor Controller independently on
other devices.
Wire the ground line. Be sure to ground the FH Sensor Controller alone.
Use an attachment power terminal (male) for installation. For details, refer to
5-3 Sensor Controller Installation on page 5 - 5.
Lit while power is ON.
Lit when an error has occurred.
Lit while the layout turned on output setting is displayed.
Blinks while the internal nonvolatile memory is accessed.
Lit while power is supplied to the SD memory card and the card is usable.
Blinks while the SD memory card is accessed.
Description
(B)
(D)
(F)
Description
3 Configuration
3
3 - 17