Omron Sysmac FH Series Hardware Setup Manual page 170

5 Setup and Wiring
3
Insert the power supply terminal connector (male) into the power supply terminal connector (fe-
male) on the sensor controller side.
4
Secure the terminal block connector (male) by tightening the screws on the right and left sides
of it with a flathead screwdriver. Recommended tightening torque: 0.5 to 0.6 N•m
4.7
5.08
Recommended Power Source for FH-L Series
The power source connected to the FH-L series Sensor Controller changes the power consumption
depending on the number of camera. Refer to the following table.
When you connect the camera using lighting Controller, the power consumption is same when connect
to the Intelligent Compact Digital Camera.
5 - 12
Terminal block connector (female)
Terminal block connector (male)
15.85
5.08
(Unit: mm)
18.2
8.3
FH Series Vision System Hardware Setup Manual (Z366-E1)