Omron Sysmac FH Series Hardware Setup Manual page 106

3 Configuration
*2. The FH-S£££ has two channels to connect Camera Cables. Connection to two channels makes image
transfer two times faster than connection to one channel: high speed mode using two channels can transfer
approximately four times as many images as standard mode using one channel.
*3. Each channel can be used to connect up to two Cable Extension Units: up to four extension units, two units
per one channel, can be connected by using two channels.
Connection Configuration
Connection configuration of FH-1000/2000/3000/5000 Sensor Controller and Camera are the bellows.
Con-
figu- Connection configuration using the maximum length of Camera
ra-
tion
1
2
3
4
*1. Select the Camera Cables between the Controller and Extension Unit, between the Extension Units, and be-
tween the Extension Unit and Camera according to the connected Camera.
Different types or lengths of Camera Cables can be used for (1), (2), and (3) as well as for (4), (5), and (6).
However, the type and length of Camera Cable (1) must be the same as those of Camera Cable (4), (2)
must be the same as (5), and (3) must be the same as (6).
3 - 46
Cables
15 m 15 m
(1) (2)
*1
CH1
15 m 15 m
(1) (2)
*1
15 m 15 m
(4) (5)
CH2
5 m 5 m
(1) (2)
*1
CH1
5 m 5 m
(1) (2)
*1
5 m 5 m
(4) (5)
CH2
15 m
(3)
15 m
(3)
15 m
(6)
5 m
(3)
5 m
(3)
5 m
(6)
FH Series Vision System Hardware Setup Manual (Z366-E1)
Remarks
-
Camera cable
connector CH2
Camera cable
connector
CH1
-
Camera cable
connector CH2
Camera cable
connector
CH1