Omron Sysmac FH Series Hardware Setup Manual page 70

3 Configuration
Component Names and Functions
(A)
(B)
(C)
(D)
(E)
(F)
Connector name
(A) SD memory card
installation con-
nector
(B) Ethernet connec-
tor
(C) USB connector
(D) RS-232C connec-
tor
(E) DVI-I connector
(F) I/O (Parallel) con-
nector (control
lines, data lines)
(G) EtherCAT address
setup volume
3 - 10
(G)
(H)
(I)
(J)
(K)
(L)
Install the SD memory card. Do not plug or unplug the SD memory card during
measurement operation. Otherwise measurement time may be affected or data
may be destroyed.
Connect an Ethernet device.
FH-1050/FH-3050
Ethernet port,
EtherNet/IP port, and
PROFINET port are
sharing use.
Connect a USB device.
Do not plug or unplug it during measurement. Otherwise measurement time may
be affected or data may be destroyed.
FH-1000/FH-3000 series
All ports: USB2.0
Connect an external device such as a PLC.
Connect a monitor.
Connect the controller to external devices such as a sync sensor and PLC.
Used to set a station address (00 to 99) as an EtherCAT communication device.
FH Series Vision System Hardware Setup Manual (Z366-E1)
Description
FH-1050-10/-20, FH-3050-10/-20
FH-2000/5000 series
Upper port :
Ethernet port
Lower port :
Ethernet port,
EtherNet/IP port, and
PROFINET port are
sharing use.
FH-2000/FH-5000 series
Left ports: USB2.0
Right ports: USB3.0
USB3.0 interface is more
capable of powering bus
power than USB2.0.
By combining USB3.0
devices, faster transmission
than USB2.0 can be
achieved.