Omron Sysmac FH Series Hardware Setup Manual page 233

Pin assignment
Wiring
Describes the connection processing to connector hood of shield as the following. The connection
processing is changed according to the transfer speed.
• 10 BASE-T/100 BASE-TX
Connect both ends of the cable shield to the connector hood. Or, connect only the shield of one end
of the cable, switching hub side, to the connector hood.
• 1000 BASE-T
Connect both ends of the cable shield to the connector hood.
FH Series Vision System Hardware Setup Manual (Z366-E1)
Pin No. Signal name
1 Communication data DA +
2 Communication data DA -
3 Communication data DB +
4 Communication data DB -
5 Communication data DC +
6 Communication data DC -
7 Communication data DD +
8 Communication data DD -
6 I/O Interface
Abbr. Signal direction
BI_DA + I/O
DI_DA - I/O
BI_DB + I/O
BI_DC + I/O
BI_DC - I/O
BI_DB - I/O
BI_DD + I/O
BI_DD - I/O
6 - 37
6