Omron Sysmac FH Series Hardware Setup Manual page 215

Corresponding model
FZ£ series
FZ£-L35£ series
F160-C10
F160
series
F160-C10CP
F160-C10CF
F210-C10
F210
series
F210-C10-ETN
F500
F500-C10
series
F250 series
F270 series
*1. If the RESET signal becomes unavailable by conversion even though the signal has been used, but it caus-
es no problem, the conversion is possible by satisfying other required conditions.
FH-VPX-FZ
l Connection Structure (FH-VPX-FZ)
PLC, terminal blocks or
other products
Connector No.
CN1
CN2
CN3
FH Series Vision System Hardware Setup Manual (Z366-E1)
Con- Applicable parallel
vertible conversion cable
Yes FH-VPX-FZ
Yes FH-VPX-FZL
Yes FH-VPX-F160
No
No
Yes FH-VPX-F210
Yes FH-VPX-F210
Yes FH-VPX-F210
No
No
Connecting the FZ-VP
* After the connection, lock it securely.
FZ-VP / FZ-VPX
Connection destination
Connect to the parallel port CN1 on the Sensor Con-
troller.
Connect to the parallel port CN2 on the Sensor Con-
troller.
Connect to the parallel I/O cable, FZ-VP£
Required conditions
•
RESET is not used.
•
The same power supply is shared in
COMIN and COMOUT.
•
RESET is not used.
•
RESET is not used.
•
The same power supply is shared in
COMIN and COMOUT.
•
Do not use DI5 and DI6.
-
-
•
RESET is not used.
•
The same power supply is shared in
COMIN and COMOUT.
•
Do not use DI8 and DI9.
-
-
FH controller
and the FH-VPX-
CN3
CN1
FH-VPX-FZ
CN2
Even if you connect the CN1 and
CN2 reversely by mistake, it does
not work but will not be damaged.
-
6 I/O Interface
*1
*1
*1
-
-
*1
-
-
Parallel connector
(CN1/CN2)
Power supply used
in the FH controller:
Power supply S8VS
series (24 VDC)
Note
6 - 19
6