Omron Sysmac FH Series Hardware Setup Manual page 171

Item
Recommended
Power Source
S8VK-G
S8VS
Mounting of FH-L Series
• Make sure to tighten all screws in mounting.
• For good ventilation, provide a clearance of 50 [mm] or more above the Sensor Controller away
from other devices in the normal floor mounting. For the right and left sides, provide a clearance of
30 [mm] or more, and for the back side, 15 [mm] or more. These clearances are also required when
mounting multiple Sensor Controllers side by side. For the back mounting, the back-side clearance
of 15 [mm] is not required.
• Do not install the product immediately above significant heat sources, such as heaters, transform-
ers, or large-capacity resistors.
• Do not install the Sensor Controller in a cabinet with high-voltage equipment installed.
• Mount the Sensor Controller at 200 [mm] or more from power cables apart.
l Mounting the base of the Sensor Controller (Floor mounting)
Clearance: 30 mm
FH Series Vision System Hardware Setup Manual (Z366-E1)
Camera type No. of camera
Intelligent Compact 2
Digital Camera
4
Camera of 2
0.3/2/4/5/12 million
pixels
4
Clearance: 50 mm
Clearance: 15 mm
Clearance: 30 mm
5 Setup and Wiring
FH-L£££ FH-L£££-££
S8VK-G12024 S8VK-G12024
S8VS-09024 S8VS-09024
S8VK-G12024
-
S8VS-12024
S8VK-G06024 S8VK-G06024
S8VS-06024 S8VS-06024
S8VK-G06024
-
S8VS-06024
5
5 - 13