Omron Sysmac FH Series Hardware Setup Manual page 218

6 I/O Interface
l Connection Structure (FH-VPX-FZL)
PLC, terminal blocks or
other products
Connector No.
CN1
CN2
CN3
CN4
*1. COM terminal polarity in NPN/PNP:
COMIN
COMOUT
6 - 22
Connecting the FZ-VP
* After the connection, lock it securely.
FZ-VP / FZ-VPX
Connection destination
Connect to the parallel port CN1 on the Sensor Con-
troller.
Connect to the parallel port CN2 on the Sensor Con-
troller.
Connect to the parallel I/O cable, FZ-VP£
Connect to 24 V power source depending on the
NPN/PNP polarity as below table.
NPN
+V -V
-V +V
FH controller
and the FH-VPX-
CN3
CN1
FH-VPX-FZL
CN4
CN2
Even if you connect the CN1 and
CN2 reversely by mistake, it does
not work but will not be damaged.
-
•
When the power source and
DIO are non-isolated and no
*1
problem:
Possible to connect the same
power source for the FH series.
•
When you want to isolate the
power source and DIO:
The power source for the FH
series cannot be used. Use an-
other power source.
Recommendations: S8VS ser-
ies, 24 VDC
PNP
FH Series Vision System Hardware Setup Manual (Z366-E1)
Parallel connector
(CN1/CN2)
Power supply used
in the FH controller:
Power supply S8VS
series (24 VDC)
Note