Enabling And Disabling Parksense; Service The Parksense Park Assist System - Jeep Gladiator 2020 Owner's Manual

Hide thumbs Also See for Gladiator 2020:
Table of Contents

Advertisement

Front Park Assist Audible Alerts
ParkSense will turn off the Front Park Assist audible alert
(chime) after approximately three seconds when an obstacle
has been detected, the vehicle is stationary, and the brake
pedal is applied.
Adjustable Chime Volume Settings
The Front and Rear chime volume settings are program-
mable.
The settings may be programmed through the Uconnect
System. Refer to "Uconnect Settings" in "Multimedia" for
further information.
The chime volume settings include low, medium, and high.
The factory default volume setting is medium.
ParkSense will retain its last known configuration state
through ignition cycles.

Enabling And Disabling ParkSense

Front ParkSense can be enabled and disabled with the Front
ParkSense switch.
Rear ParkSense can be enabled and disabled with the Rear
ParkSense switch.
When the Front or Rear ParkSense switch is pushed
to disable the system, the instrument cluster display
will show the "PARKSENSE OFF" message for
approximately five seconds. Refer to "Instrument Cluster
Display" in "Getting To Know Your Instrument Panel" for
further information.
When the gear selector is moved to REVERSE and the Front
or Rear system is disabled, the instrument cluster display
will show the "PARKSENSE OFF" message for as long as the
vehicle is in REVERSE.
The Front or Rear ParkSense switch LED will be on when
Front or Rear ParkSense is disabled or requires service. The
Front or Rear ParkSense switch LED will be off when the
Front or Rear system is enabled. If the Front or Rear Park-
Sense switch is pushed, and the system requires service, the
Front or Rear ParkSense switch LED will blink momentarily,
and then the LED will be on.

Service The ParkSense Park Assist System

During vehicle start up, when the ParkSense System has
detected a faulted condition, the instrument cluster will
actuate a single chime, once per ignition cycle, and it will
display the "PARKSENSE UNAVAILABLE WIPE REAR
SENSORS", "PARKSENSE UNAVAILABLE WIPE FRONT
STARTING AND OPERATING
353
5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents