Parkview Rear Back Up Camera - Jeep Gladiator 2020 Owner's Manual

356 STARTING AND OPERATING
CAUTION!
• ParkSense is only a parking aid and it is unable to
recognize every obstacle, including small obstacles.
Parking curbs might be temporarily detected or not
detected at all. Obstacles located above or below the
sensors will not be detected when they are in close
proximity.
• The vehicle must be driven slowly when using Park-
Sense in order to be able to stop in time when an
obstacle is detected. It is recommended that the driver
looks over his/her shoulder when using ParkSense.

PARKVIEW REAR BACK UP CAMERA

The ParkView Rear Back Up Camera allows you to see an
on-screen image of the rear surroundings of your vehicle
whenever the gear selector is in REVERSE. The image will be
displayed in the touchscreen display along with a caution
note to "check entire surroundings" across the top of the
screen. After five seconds this note will disappear. The
ParkView camera is located on the tailgate, above the vehicle
license plate.
Manual Activation Of The Rear View Camera
1. Go to the Controls screen by pressing the "Controls"
button located on the bottom of the Uconnect display,
and then press "Backup Camera".
2. Press the "Backup Camera" button to turn the Rear View
Camera system on.
NOTE:
For vehicles equipped with the Uconnect 3 With 5-Inch
Display, there is only one option for manual activation of the
Rear View Camera. Press the "More" hard button on the
Uconnect system, and then press "Backup Camera".
When the vehicle is shifted out of REVERSE (with Camera
delay turned off), the rear Camera mode is exited and the
previous screen appears again.
When the vehicle is shifted out of REVERSE (with Camera
delay turned on), the rear Camera image will be displayed
for up to 10 seconds unless the vehicle speed exceeds 8 mph
(13 km/h), the transmission is shifted into PARK, the igni-
tion is cycled to the OFF position, or the touchscreen button
"X" to disable display of the Rear View Camera image is
pressed.