Battery Saver On, Battery Saver Mode Message, And Electrical Load Reduction Actions (If Equipped) - Jeep Gladiator 2020 Owner's Manual

176 GETTING TO KNOW YOUR INSTRUMENT PANEL
• Fuel Economy (show/hide)
• Trip Info (show/hide)
• Stop/Start — If Equipped
• Audio (show/hide)
• Messages
• Screen Setup
• Off Road — If Equipped (show/hide)
Gear Display — Premium Cluster Only
• Full (default)
• Single
Current Gear
• Off (default)
• On
Odometer
• Show (default)
• Hide
Defaults
• Cancel
• Restore
Battery Saver On, Battery Saver Mode Message, And
Electrical Load Reduction Actions (If Equipped)
This vehicle is equipped with an Intelligent Battery Sensor
(IBS) to perform additional monitoring of the electrical
system and status of the vehicle battery.
In cases when the IBS detects charging system failure, or the
vehicle battery conditions are deteriorating, electrical load
reduction actions will take place to extend the driving time
and distance of the vehicle. This is done by reducing power
to or turning off non-essential electrical loads.
Load reduction is only active when the engine is running. It
will display a message if there is a risk of battery depletion to
the point where the vehicle may stall due to lack of electrical
supply, or will not restart after the current drive cycle.
When load reduction is activated, the message "Battery
Saver On Some Systems May Have Reduced Power" will
appear in the instrument cluster.
These messages indicate the vehicle battery has a low state of
charge and continues to lose electrical charge at a rate that
the charging system cannot sustain.