To Start The Engine While In Autostop Mode; To Manually Turn Off The Stop/Start System - Jeep Gladiator 2020 Owner's Manual

To Start The Engine While In Autostop Mode

While in a forward gear, the engine will start when the brake
pedal is released or the throttle pedal is depressed. The trans-
mission will automatically re-engage upon engine restart.
Conditions That Will Cause The Engine To Start Automat-
ically While In Autostop Mode:
• The transmission selector is moved out of DRIVE
• To maintain cabin temperature comfort
• Actual cabin temperature is significantly different than
temperature set on Auto HVAC
• HVAC is set to full defrost mode
• HVAC system temperature or fan speed is manually adjusted
• Battery voltage drops too low
• Low brake vacuum (e.g. after several brake pedal applica-
tions)
• STOP/START OFF switch is pushed
• A Stop/Start system error occurs
• STOP/START AUTO STOP ACTIVE time exceeds 5 minutes
• 4WD system is put into 4L or Neutral mode
• Steering wheel is turned beyond threshold

To Manually Turn Off The Stop/Start System

1. Push the STOP/START OFF switch (located on the
switch bank). The light on the switch will illuminate.
STOP/START Off Switch
2. The "STOP/START OFF" message will appear in instru-
ment cluster display within the Stop/Start section. Refer
to "Instrument Cluster" in "Getting To Know Your
Instrument Panel" for further information.
3. At the next vehicle stop (after turning off the STOP/
START system), the engine will not be stopped.
4. The Stop/Start system will reset itself back to an ON condi-
tion every time the ignition is turned off and back on.
STARTING AND OPERATING 313
5