Table of Contents
Advertisement
132
GETTING TO KNOW YOUR INSTRUMENT PANEL
Screen Setup Driver Selectable Items
Upper Left and Right
Current MPG
None
(or L/100km,
km/L)
Outside Temp
Compass
Range To Empty Time
Center
None
Compass
Average MPG
Outside Temp
(or L/100km,
km/L)
Range to Empty
Audio
Current MPG
(or L/100km,
Trip B Distance
km/L)
Favorite Menus
Speedometer
Stop/Start
Off Road –
If Equipped
Messages
(show/hide)
Fuel Economy
Screen Setup
(show/hide)
Audio
(show/hide)
Gear Display — If Equipped
•
Full
•
Single
Current Gear — If Equipped
Average MPG
(or L/100km,
•
On
km/L)
•
Off
Trip A Distance
Odometer — If Equipped
Trip B Distance
•
Show
•
Hide
Defaults (Restores All Settings To Default Settings)
Time
•
Cancel
•
Restore
Trip A Distance
The menu with (show/hide) means user can press OK
button to choose show or hide this menu on the instru-
Speedometer
ment cluster display.
Phone Call Status — If Equipped
Menu Title
A pop-up message for an incoming call will appear on
any screen within your instrument cluster. The pop-up
message will appear on your screen until it is cleared
out of the call is ignored, answered, or the calling ends.
Vehicle Info
NOTE:
Driver Assist –
The Uconnect Settings can be programmed to turn the
If Equipped
pop-up off. This will not affect the audio menu or any
(show/hide)
phone status information
Trip Info
Any incoming calls, active calls, and outgoing calls will
(Show/Hide)
take the place of your audio information.
A caller's name will only be displayed if:
•
A number is associated with the call. The phone num-
ber will be displayed in place of the caller's name.
•
The test/font of the name is not supported by the
instrument cluster. The instrument cluster will not
display anything in place of the name.
•
The caller's name exceeds the maximum number of
characters. The last two to three digits that will fit
will be replaced with "...".
NOTE:
Any audio information will return to the instrument clus-
ter once the call has ended.
BATTERY SAVER ON/BATTERY
SAVER MODE MESSAGE —
ELECTRICAL LOAD REDUCTION
ACTIONS — IF EQUIPPED
This vehicle is equipped with an Intelligent Battery Sen-
sor (IBS) to perform additional monitoring of the electri-
cal system and status of the vehicle battery.
In cases when the IBS detects charging system failure,
or the vehicle battery conditions are deteriorating, elec-
trical load reduction actions will take place to extend
the driving time and distance of the vehicle. This is
done by reducing power to or turning off non-essential
electrical loads.
Load reduction is only active when the engine is run-
ning. It will display a message if there is a risk of battery
depletion to the point where the vehicle may stall due
to lack of electrical supply, or will not restart after the
current drive cycle.
page 201.
When load reduction is activated, the message "Battery
Saver On" or "Battery Saver Mode" will appear in the
instrument cluster display.
These messages indicate the vehicle battery has a low
state of charge and continues to lose electrical charge
at a rate that the charging system cannot sustain.
Advertisement
Table of Contents
