Battery Saver On, Battery Saver Mode Message, And Electrical Load Reduction Actions (If Equipped) - Jeep GLADIATOR 2022 Owner's Manual

108 GETTING TO KNOW YOUR INSTRUMENT PANEL
When no messages are present, main menu icon will
be a closed envelope, and "No Stored Messages" will
display.
Screen Setup
NOTE:
The Screen Setup feature can only be used while the
vehicle is not in motion.
Push and release the up or down
until the Screen Setup Menu Icon/Title is highlighted in
the instrument cluster display. Push and release the OK
button to enter the submenus and follow the prompts
on the screen as needed. The Screen Setup feature
allows you to change what information is displayed in
the instrument cluster as well as the location in which
that information is displayed.
NOTE:
Based upon equipment options and current vehicle
status, some of the features may not be available.
Screen Setup Driver Selectable Items
Upper Left
None Time
Compass Range to Empty
Outside Temp Average Econ
Upper Right
None Time
Compass Range to Empty
Outside Temp Average Econ
None
Compass
Audio
Outside Temp
arrow button
Speedometer
Driver Assist —
If Equipped
(show/hide)
Stop / Start —
If Equipped
Screen Setup
Gear Display — If Equipped
•
Full
•
Single
Current Gear
Current Econ
•
Off
Trip A Distance
•
On
Trip B Distance
Odometer
•
Show
•
Hide
Current Econ
Defaults
Trip A Distance
•
Cancel
Trip B Distance
•
Restore
Upper Center
Time Current Econ
Range to Empty Trip A Distance
Average Econ Trip B Distance
Menu Title Speedometer
Favorite Menus
Vehicle Info Off Road —
If Equipped
(show/hide)
Fuel Economy Trip Info
(show/hide) (show/hide)
Audio Messages
(show/hide)
Vehicle Settings
— If Equipped
BATTERY SAVER ON, BATTERY
SAVER MODE MESSAGE, AND
ELECTRICAL LOAD REDUCTION
ACTIONS (IF EQUIPPED)
This vehicle is equipped with an Intelligent Battery Sen-
sor (IBS) to perform additional monitoring of the electri-
cal system and status of the vehicle battery.
In cases when the IBS detects charging system failure,
or the vehicle battery conditions are deteriorating, elec-
trical load reduction actions will take place to extend
the driving time and distance of the vehicle. This is
done by reducing power to or turning off non-essential
electrical loads.
Load reduction is only active when the engine is run-
ning. It will display a message if there is a risk of battery
depletion to the point where the vehicle may stall due
to lack of electrical supply, or will not restart after the
current drive cycle.
When load reduction is activated, the message "Battery
Saver On Some Systems May Have Reduced Power" will
appear in the instrument cluster.
These messages indicate the vehicle battery has a low
state of charge and continues to lose electrical charge
at a rate that the charging system cannot sustain.
NOTE:
•
The charging system is independent from load
reduction. The charging system performs a diagnos-
tic on the charging system continuously.
•
If the Battery Charge Warning Light is on it may indi-
cate a problem with the charging system
page 113.