Garmin GTN 625 Pilot's Manual page 598

Voice Command Instructions
Foreword
1. Press and hold the Push to Command (PTC) switch.
Getting
2. Speak the entire command into the headset MIC.
Started
3. Release the "PTC" switch.
Audio &
Xpdr Ctrl
Com/Nav
FPL
Direct-To
Successful Command Example
"Show approaches page" is spoken, the approach selection page displays
Proc
immediately, and a positive tone sounds.
Wpt Info
Unsuccessful Command Examples
"Show map page" is spoken and the traffic page displays.
Map
"Show map page" is spoken and a negative tone sounds.
Traffic
Qualification Procedure
Terrain
Speak the non-bold phrase if the voice command for a procedure is not
applicable to the aircraft' s configuration. If the total number of successful
Weather
commands is less than 17, the voice commands must be disabled. For instructions
on how to activate and deactivate voice commands, refer to section 15.13.
Nearest
Example: If the requirement states a COM radio is required, but your GTN
Services/
does not a have a COM radio, use the unbold command.
Music
1. Start the GTN and acquire a GPS position.
Utilities
2. Conduct the voice commands in sequential order while wearing
System
Messages
3. When the command is successful check the box next to the
Symbols
Appendix
Index
18-26
• A positive tone (low-to-high) indicates the command has been
recognized and executed. (i.e., page changed, radio tuned, MIC
selected, etc.)
• A negative tone (high-to-low) indicates the command is either
unrecognizable or invalid.
an aviation headset. If necessary, a command can be attempted
twice.
command.
GTN 625/635/650 Pilot's Guide 190-01004-03 Rev. P