Marker Beacon Annunciations - Garmin GTN 625 Pilot's Manual

NOTE: The XPDR/TCAS Mode on the Transponder Control Panel always
Foreword
shows the pilot-selected mode and does not necessarily correspond with
the traffic system if it is in a lower mode due to other constraints. The active
Getting
Started
mode is shown in the radio bar next to the transponder squawk code.
Audio &
Xpdr Ctrl
XPDR/TCAS Mode
Selection
Com/Nav
TA/RA
TA Only
FPL
Altitude Reporting
Direct-To
On
Standby
Proc
Wpt Info
2.2
When connected to a compatible audio panel, a visual annunciation of marker
Map
beacons will be shown on the display when the aircraft flies over a marker beacon.
Traffic
The annunciation will appear in the lower left of the display.
Current Beacon
Terrain
Inner Marker
Weather
Middle Marker
Outer Marker
Nearest
The marker beacon alternates between the standard icon and the blink icon at
Services/
the blink interval corresponding to the current beacon.
Music
Utilities
System
Messages
Symbols
Appendix
Index
2-10
Altitude Reporting
Altitude Reporting
Altitude Reporting
On
Standby
Table 2-2 Transponder and TCAS II Modes

Marker Beacon Annunciations

Icon (Standard)
Table 2-3 Marker Beacons
GTN 625/635/650 Pilot's Guide
Transponder
Mode
Icon (Blink)
Available TCAS II
Modes
TA/RA or TA Only
TA Only
Standby
Standby
Standby
Blink Interval
250 ms
333 ms
750 ms
190-01004-03 Rev. P