Direct-To A User-Defined Hold - Garmin GTN 625 Pilot's Manual

5.8
Foreword
NOTE:
Getting
Started
NOTE:
the "Activate the Direct-To Hold" key, navigation guidance will be given back
Audio &
Xpdr Ctrl
to the holding fix and the new hold re-initiated.
Com/Nav
A user-defined hold can be created as part of a Direct-To to any waypoint.
Automatic waypoint sequencing will be suspended during the hold.
FPL
Direct-To
Proc
Wpt Info
Map
Traffic
Terrain
Touch to Select
Specific Course
Weather
Touch to Select
Leg Length Type
Nearest
Touch to Preview
Selected Hold
Services/
Music
Utilities
System
Messages
Symbols
Appendix
Index
5-8

Direct-To a User-Defined Hold

This feature is available in software v6.00 and later.
Any time a user hold is changed with the Direct-To key, upon pressing
1. Press the Direct-To key to display the Direct-To page.
Figure 5-11 Create Hold at Direct-To Waypoint
2. Touch the Hold key. The Direct-To Hold page is displayed.
Touch to Select Direction
Touch to Select Leg Length
Figure 5-12 Entering Direct-To Hold Parameters
3. Touch the Course key to open the keypad. Use the keypad
and the Enter key to select the inbound or outbound course.
4. Touch the Direction key to select between Inbound or
Outbound for the course direction.
5. Touch the Turn key to select between Left or Right for the turn
direction.
6. Touch the Leg Type key to select between Time or Distance
for the leg type.
7. Touch the Leg Time or Leg Distance key to display the keypad.
Use the keypad and the Enter key to select the length of the leg.
GTN 625/635/650 Pilot's Guide
Direct-To Wpt
Touch to Select
Specific Course
Touch to Create Hold
at Direct-To Wpt
Touch to Select
Turn Direction
Touch to Select
EFC Time
Touch to Accept
Hold Parameters
190-01004-03 Rev. P