Selecting A Squawk Code - Garmin GTN 625 Pilot's Manual

2.1.5
Foreword
The selected squawk code will always be in use. As you change a squawk
Getting
code, the original code will be used until you are finished selecting the new code.
Started
Squawk Code
Audio &
Xpdr Ctrl
1200
7500
Com/Nav
7600
FPL
7700
Direct-To
Proc
Wpt Info
Map
Traffic
Terrain
Active XPDR
Weather
Nearest
Numeric Keypad
Services/
Music
Utilities
System
Messages
Symbols
Appendix
Index
2-6

Selecting a Squawk Code

Default VFR code in the USA
Hijacking
Loss of Communications
Emergency
Table 2-1 XPDR Special Squawk Codes
1. Touch the transponder squawk code window at the right side
of the display.
2. The XPDR page will be displayed. The Squawk Code value will
be active for selection for use by the active Transponder.
3. Touch the numeric keypad, or use the rotary knobs, to select
the desired Squawk Code.
4. Then, touch Enter.
Squawk Code Window
Figure 2-12 XPDR Squawk Code Selection Display
5. The selected Squawk Code will be shown in the XPDR window
on the right side of the display.
GTN 625/635/650 Pilot's Guide
Description
Squawk Code Backspace Key
190-01004-03 Rev. P
Enter Key