Garmin GTN 625 Pilot's Manual page 477

9. After completing the Trip Planning selections, touch the
Compute Data key to display the trip statistics.
Figure 14-21 Utility Trip Planning Page With Computed Data (Point-To-Point Mode)
NOTE: When Local Time is selected in the Setup-Date/Time feature, Sunrise/
Sunset calculations in the Trip Planning feature are based on the From
waypoint time zone. For instance, a flight plan originating in the Pacific
time zone and ending in the Central time zone would show Sunset/Sunrise
times at the destination in Pacific time. This potential offset does not occur
when UTC time is used.
14.4.2 Flight Plan Mode
1. Touch the Mode key to select Flight Plan mode, if required.
Touch to Select
Flight Plan
From Catalog
Touch to Toggle
Sensor Data Use
Touch to Select
Departure Time
Figure 14-22 Utility Trip Planning Page Edit Input Data View (Flight Plan Mode)
2. Touch the Flight Plan key to select the flight plan.
190-01004-03 Rev. P
Touch to Select
Departure Date
Figure 14-23 Select Flight Plan
GTN 625/635/650 Pilot's Guide
Trip Statistics
Touch to Toggle
Between Statistics
and Data Input
Touch to Select
Flight Plan Leg
Touch to Select
P-to-P or Flight
Plan Mode
Touch to Toggle
Between Statistics
and Data Input
Touch to Select
Expected Average
Ground Speed
Touch to Select
Flight Plan (Active
FPL Shown)
Touch to Scroll List
Foreword
Getting
Started
Audio &
Xpdr Ctrl
Com/Nav
FPL
Direct-To
Proc
Wpt Info
Map
Traffic
Terrain
Weather
Nearest
Services/
Music
Utilities
System
Messages
Symbols
Appendix
Index
14-17