Squawk Code Keys; Vfr; Xpdr Key - Garmin GTN 650Xi Series Pilot's Manual

Squawk Code Keys

SPECIAL SQUAWK CODES
1200 Default VFR code (USA)
7500 Hijacking
7600 Loss of communications
7700 Emergency

VFR

XPDR Key

Active
Transponder
Active Squawk
Code
190-02327-03 Rev. C
Digits that are not yet entered appear as underscores.
Activate the new code by tapping Enter. To cancel the
code entry and exit the page, tap Cancel.
Active squawk codes remain in use until a new code is
entered.
Tapping this key once sets the squawk code to the
preprogrammed VFR code.
This code is factory set to 1200, but may be changed
during configuration.
Transponder
Mode (On)
Pilot's Guide
Eight squawk code entry keys (0 – 7)
provide access to all ATCRBS codes.
Tapping one of these keys begins the
code selection sequence.
Use the Backspace key or outer
control knob to move the cursor.
Tapping the XPDR key activates
the IDENT function for 18 seconds.
This signal distinguishes the
transponder from others on the air
traffic controller's screen.
Tapping this key when another
page is active immediately opens
the control panel.
Get Started
2-59