Cisco Nexus 5000 Series Interfaces Command Reference - Cisco Nexus 5000 Series Command Reference Manual

Show Commands
Table 1: show interface ethernet brief Field Description
Field
Ethernet Interface
VLAN
Type
Mode
Status
Reason
Speed
Port Ch #
This example shows how to display the MAC address of a specified subinterface:
switch# show interface ethernet 1/5.2
mac-address
--------------------------------------------------------------------------------
Interface
--------------------------------------------------------------------------------
Ethernet1/5.2
switch#
Related Commands
Command
interface ethernet
interface ethernet (Layer 3)
switchport mode vntag
switchport monitor rate-limit
Description
Ethernet interface information.
VLANs associated with the Ethernet interface.
Type of interface.
Mode configured for the interface: access, trunk,
routed (applies to Layer 3 interfaces), and vlan.
Indicates whether the interface hardware is currently
active (up), is currently inactive (down), or has been
taken down by an administrator (administratively
down).
Indicates the reason the interface is inactive or
administratively down.
Interface speed.
EtherChannel associated with the interface.
Mac-Address Burn-in Mac-Address
0005.73a6.1dbc 0005.73a6.1d6c
Description
Configures an Ethernet IEEE 802.3 interface.
Configures a Layer 3 Ethernet IEEE 802.3 interface.
Configures an Ethernet interface as a VNTag port.
Configures the rate limit for traffic on an interface.

Cisco Nexus 5000 Series Interfaces Command Reference

show interface ethernet
119