Cisco Nexus 5000 Series Command Reference Manual page 159

Show Commands
l4-src-port
src-port
src-ip
src-ipv6
src-mac
src-mac-addr
Command Default
None
Command Modes
EXEC mode
Command History
Release
4.0(0)N1(1a)
4.2(1)N1(1)
Usage Guidelines
You must use the vlan keyword to determine the use of hardware hashing.
When you do not use hardware hashing, the output displays all parameters used to determine the outgoing
port ID. Missing parameters are shown as zero values in the output.
If you do not use hardware hashing, the outgoing port ID is determined by using control-plane selection.
Hardware hashing is not used in the following scenarios:
• The specified VLAN contains an unknown unicast destination MAC address.
• The specified VLAN contains a known or an unknown multicast destination MAC or destination IP
• The specified VLAN contains a broadcast MAC address.
• The EtherChannel has only one active member.
• The destination MAC address is unknown when the load distribution is configured on the source IP
address.
address (src-ip), source port (l4-src-port), or source MAC address (src-mac).
(Optional) Displays the load distribution on the source
port.
Source port number. The range is from 0 to 65535.
(Optional) Displays the load distribution on the source
IP address.
(Optional) Displays the load distribution on the source
IPv6 address.
(Optional) Displays the load distribution on the source
MAC address.
source MAC address. The format is AA :BB :CC :DD
:EE :FF .
Modification
This command was introduced.
The vlan keyword was added.
Cisco Nexus 5000 Series Interfaces Command Reference
show port-channel load-balance
149