Peer-Switch - Cisco Nexus 5000 Series Command Reference Manual

peer-switch

peer-switch
To enable the virtual port channel (vPC) switch pair to appear as a single Spanning Tree Protocol (STP) root
in the Layer 2 topology, use the peer-switch command. To disable the peer switch vPC topology, use the no
form of this command.
peer-switch
no peer-switch
Syntax Description
This command has no arguments or keywords.
Command Default
Peer switch Layer 2 topology is disabled.
Command Modes
vPC domain configuration mode
network-admin
Command History
Release
5.2(1)N1(1)
Usage Guidelines
This command does not require a license.
Examples This example shows how to enable the vPC switch pair to appear as a single STP root in the Layer 2 topology:
switch(config)#
vpc domain
5 switch(config-vpc-domain)#
peer-switch 2010 Apr 28 14:44:44 switch
%STP-2-VPC_PEERSWITCH_CONFIG_ENABLED: vPC peer-switch configuration is enabled.
Please make sure to configure spanning tree "bridge" priority as per
recommended guidelines to make vPC peer-switch operational.
Related Commands
Command
vpc domain
Cisco Nexus 5000 Series Interfaces Command Reference
78
Modification
This command was introduced.
Description
Creates a virtual port-channel (vPC) domain.
P Commands