Errdisable Detect Cause - Cisco Nexus 5000 Series Command Reference Manual

errdisable detect cause

errdisable detect cause
To enable error-disable (err-disabled) detection in an application, use the errdisable detect cause command.
To disable error disable detection, use the no form of this command.
errdisable detect cause {all| link-flap| loopback}
no errdisable detect cause {all| link-flap| loopback}
Syntax Description
all
link-flap
loopback
Command Default
Enabled
Command Modes
Global configuration mode
Command History
Release
4.2(1)N1(1)
Usage Guidelines
When error disable detection is enabled and a cause is detected on an interface, the interface is placed in an
err-disabled state, which is an operational state that is similar to the link-down state.
Examples This example shows how to enable the err-disabled detection on linkstate-flapping:
switch(config)# errdisable detect cause link-flap
switch(config)#
Related Commands
Command
errdisable recovery
show interface status err-disabled
Cisco Nexus 5000 Series Interfaces Command Reference
26
Enables error detection on all cases.
Enables error disable detection on linkstate-flapping.
Enables error disable detection on loopback.
Modification
This command was introduced.
Description
Configures recovery from the err-disabled state.
Displays the interface error disabled state.
E Commands