show interface ethernet
Release
5.0(3)N1(1)
Usage Guidelines
If the interface and transceiver speed is mismatched, the SFP validation failed message is displayed when you
enter the show interface ethernet slot /port command. For example, if you insert a 1-Gigabit SFP transceiver
into a port without configuring the speed 1000 command, you will get this error.
By default, all ports on a Cisco Nexus 5000 Series switch are 10 Gigabits.
Examples
This example shows how to display the detailed configuration of the specified interface:
switch# show interface ethernet 1/1
Ethernet1/1 is up
Hardware: 1000/10000 Ethernet, address: 000d.ece7.df48 (bia 000d.ece7.df48)
MTU 1500 bytes, BW 10000000 Kbit, DLY 10 usec,
Encapsulation ARPA
Port mode is fex-fabric
full-duplex, 10 Gb/s, media type is 1/10g
Beacon is turned off
Input flow-control is off, output flow-control is off
Rate mode is dedicated
Switchport monitor is off
Last link flapped 09:03:57
Last clearing of "show interface" counters never
30 seconds input rate 2376 bits/sec, 0 packets/sec
30 seconds output rate 1584 bits/sec, 0 packets/sec
Load-Interval #2: 5 minute (300 seconds)
RX
TX
1 interface resets
switch#
This example shows how to display the counters configured on a specified interface:
switch# show interface ethernet 1/1 counters
--------------------------------------------------------------------------------
Port
--------------------------------------------------------------------------------
Eth1/1
--------------------------------------------------------------------------------
Port
Cisco Nexus 5000 Series Interfaces Command Reference
116
reliability 255/255, txload 1/255, rxload 1/255
input rate 1.58 Kbps, 0 pps; output rate 792 bps, 0 pps
0 unicast packets
10440 multicast packets
10440 input packets
11108120 bytes
0 jumbo packets
0 storm suppression packets
0 runts
0 giants
0 CRC
0 input error
0 short frame
0 watchdog
0 bad etype drop
0 input with dribble
0 input discard
0 Rx pause
0 unicast packets
20241 multicast packets
20346 output packets
7633280 bytes
0 jumbo packets
0 output errors
0 collision
0 lost carrier
0 no carrier
0 Tx pause
InOctets
17193136
OutOctets
Modification
Support for Layer 3 interfaces and subinterfaces, and Adapter Fabric
Extender (Adapter-FEX) was added.
The switchport keyword was added.
0 broadcast packets
0 no buffer
0 overrun
0 underrun
0 bad proto drop
105 broadcast packets
0 deferred
0 late collision
0 babble
InUcastPkts
0
OutUcastPkts
OutMcastPkts
0 ignored
0 if down drop
InMcastPkts
InBcastPkts
16159
OutBcastPkts
Show Commands
0