Cisco Nexus 5000 Series Interfaces Command Reference - Cisco Nexus 5000 Series Command Reference Manual

Show Commands
full-duplex, 10 Gb/s
Beacon is turned off
Input flow-control is on, output flow-control is on
Switchport monitor is off
Members in this channel: Eth2/3
Last clearing of "show interface" counters never
30 seconds input rate 0 bits/sec, 0 packets/sec
30 seconds output rate 352 bits/sec, 0 packets/sec
Load-Interval #2: 5 minute (300 seconds)
RX
TX
1 interface resets
switch#
Related Commands
Command
interface port-channel
input rate 0 bps, 0 pps; output rate 368 bps, 0 pps
0 unicast packets 0 multicast packets
0 input packets 0 bytes
0 jumbo packets 0 storm suppression packets
0 runts 0 giants 0 CRC
0 input error 0 short frame
0 watchdog 0 bad etype drop
0 input with dribble 0 input discard
0 Rx pause
0 unicast packets 15813 multicast packets
15822 output packets 1615917 bytes
0 jumbo packets
0 output errors 0 collision
0 lost carrier 0 no carrier
0 Tx pause
0 broadcast packets
0 no buffer
0 overrun 0 underrun
0 bad proto drop 0 if down drop
9 broadcast packets
0 deferred 0 late collision
0 babble
Description
Configures an EtherChannel interface.

Cisco Nexus 5000 Series Interfaces Command Reference

show interface port-channel
0 ignored
129