Configure Network Parameters - Avaya S8300 Series Replacement Manual

4. If the update that you want to activate shows unpacked in the Status column, select the file
(radio button) and click Activate.
The status of the activation process displays on the screen. If a reboot is required, the
system automatically reboots.
5. Click on Yes.
Wait until the system displays the Continue button.
6. Click Continue.

Configure network parameters

If you backed up the server data to a USB CompactFlash card / reader, omit this section and
continue with Restore Data
Note:
You must have the host name, subnet mask, and IP addresses of the server and
Note:
default gateway to complete this procedure.
To configure the network parameters on the server:
1. On the Communication Manager System Management Interface main page, from the
Installation menu, select Configure Server.
The Configure Server wizard launches.
2. Click Continue until you get to the "Specify how you want to use this wizard" screen.
3. Select Configure individual services and click Continue.
4. Click Set Identities from the Configure Individual IP Services list on the left.
The system displays the Set Identities screen.
5. Fill in the host name with the name of the server.
6. Click Continue.
The system displays the Configure Interfaces screen.
7. Fill in the correct server and gateway IP addresses, the subnet mask, and, if
Communication Manager Messaging is installed, its IP address (but not if this server is an
LSP).
If these fields are already filled in, overwrite them with the correct information. Leave the
Integrated Message field blank.
8. Click Change to update the system files.
on page 32. Otherwise, complete this entire section.
Configure network parameters
03-300528 Issue 6 May 2009 31