Detail Pages: Inputs And Outputs; General; Analog Outputs - Siemens Climatix Series Basis Document

Note
Access level
Caution
Access
Example
Parameter
Parameter
Manual operation
Manual operation
Present Value
Siemens
Building Technologies
6

Detail pages: Inputs and outputs

6.1

General

This section describes all the detail pages for analog and digital inputs and outputs
as well as multistate (=digital modulating) outputs.
Most of the listed and briefly outlines values are parameters are designed exclu-
sively for experts.
Possible reliability states (messages) for the base controller and the extension
modules may differ.
Detail pages can only be read/written at the following access levels:
• Read: Levels 6, 4 and 2, Special Settings with levels 4 and 2 only.
• Write: Levels 4 and 2.
Changes to parameters and settings may have a massive impact on plant opera-
tion and safety.
6.2

Analog outputs

6.2.1 General
The details page for analog outputs can be reached multiple ways, including:
• Main Index > Unit > Outputs > Analog outputs > Plant Element
or
• Main Index > Unit > Element Control > Analog Element > Output Signal
• Main Index > Unit > Outputs > Analog outputs > Exh fan outp signal
or
• Main Index > Unit > Fan Control > Exhaust fan > Output signal
Range
0...100 [%]
– NULL
– Active
0...100 [%]
Basis Document Siemens Climatix Control System
Standard application AHU
BDCX.100820.01GB
Detail pages: Inputs and outputs
Function
Manual intervention on the output. The output goes
directly to manual operation when entering a value
(for 0 as well). Is not automatically reset. An alarm
can be triggered after a set period when the manual
alarm function is enabled.
– Auto: The program controls the output. Reset a
manual intervention to auto mode.
– Displays a manual intervention. The value en-
tered above (0...100 %) controls the output.
Present value for output.
95 / 244
CE1P3977en_02
Page 95
01.02.2010